3" to 4" Selkirk VP Pellet Vent Pipe Thru-the-Wall Kit - 3/4VP-KIT

The Selkirk 3/4VP Thru-the-Wall Pellet Stove Kit is designed for horizontal installations only.

• 1 - 4" 90° Elbow
• 1 - 4" Tee Support
• 1 - 4" Wall Bracket
• 1 - 4" Wall Thimble
• 1 - 4" Horizontal Cap
• 1 - 4" Pipe Connector
• 1 - 3" Pipe Connector
• 1 - 4" Tee with Cleanout
• 1 - 3" to 4" Pellet Increaser
• 5 - 4" One-foot Pipe Lengths

VP Pellet Pipe is used for venting pellet or corn burning stoves approved for use with PL-Vent. The appliance's flue gases must not exceed 570° F (298.80° C).

See all 4" VP Pellet Pipe Components

Additional Information:

Metalbestos gives you the safe, efficient, and cost-effective venting system that's engineered precisely for pellet and corn burning stoves. Model VP Pellet Pipe has been tested and listed by Underwriters' Laboratories, Inc., in accordance with UL-641 Standard for Low Temperature Venting Systems, as well as the applicable requirements from UL-103 Standard for Residential Type and Building Heating Appliance Chimneys. Model VP Pellet Pipe, when installed according to Metalbestos installation instructions, complies with National Safety Standards, such as NFPA-211. The system is rated for flue temperatures up to 570° F.

• Diameter: 4"
• Clearances: 3" clearance to combustibles
• Listings: UL 641 (Standard for Low Temperature Venting). UL 103 (Standard for Residential Type and Building Heating Appliance Chimneys)
• 1 - 4" Horizontal Cap
• 1 - 4" 90° Elbow
• 1 - 4" Wall Bracket
• 5 - 4" One-foot Pipe Lengths
• 1 - 4" Tee with Cleanout
• 1 - 4" Wall Thimble
• 1 - 4" Tee Support
• 1 - 3" to 4" Pellet Increaser
• 1 - 4" Pipe Connector
• 1 - 3" Pipe Connector